“small panel” molded decoration, pt. 2

Well, I told you this was a practice piece. yesterday was one of those afternoons when all craft skills evaded me. But I can show you the steps to finish the so-called “small panel” decoration. Just not a neat job of it. This first photo is using the same molding cutter, now mounted to scrape the profile on the edges of a thin strip (1/4″ or less in thickness) to be cut into the inserts.

edge molding a strip for inserts

Holding that thin strip is tricky. I simply nailed it down to a piece of scrap pine. That gets it up high enough to clear the fence portion of the scratch stock. Cutting the first two miters on a blank is easy – there’s a length of material to hold. I got this miter box from Jennie Alexander umpteen years ago, tried to sell it. No dice, but glad now I didn’t get rid of it.

miter box

Once those two miters are cut, I lay the piece in place, and scribe its length based on the distance between two rows of molding. Ideally, it’s the same from row to row. Mine aren’t. They’re close. When I do a box front like this for keeps, I’d cut up a number of blanks and scribe all the housings in one pass. I was going back & forth for the photos & videos I was shooting. So a bit clunky and inefficient.

scribing the length

I didn’t shoot photos of cutting the 2nd set of miters, on a piece that’s now about 1″ to 1 1/4″ long. Hard to hold that little devil in the miter box. I fumbled around with a couple of options using clamps. Too cumbersome. Finally just pinned it in place with my left hand and LIGHTLY sawed. Key word is lightly. Any extra pressure shifts the blank aside & ruins the miter. Next, I used a square to line it up, as preparation for scribing its placement.

squared up

Make sure it doesn’t shift on this next step either, scribing its edges and miters.

more scribing

Then comes the chisel work. Chopping down to sever the fibers. I’m working inside my scribed lines. I’ll sneak up to them.

chisel work, pt 1

Now, bevel down. chop out the waste. Some back & forth with chopping down into the fibers, then cutting out the waste.

stock removal

Once you’ve got that bottom flattened out, and all the bits removed it’s time to cut to the scribed lines. Set the chisel right on the line, and chop it.

last cuts

It will take some practice to get to the point where I can cut the inserts spot-on, then the housing ditto. But this shot gives you the concept of alternating these faux muntins to divide up the rows of moldings.

starting to see the pattern

In many cases, it seems that these mini-panel frames were painted black. To me, that seems to defeat the effect of the molding. But it does hide a multitude of sins. Here’s a chest of drawers I made back about 2002, showing that black paint scheme. (the low light in that room is giving the black that blue cast…) Paint might save yesterday’s efforts, but I still think I’ll do it over.