Beginning the basket/cradle

Today was basket weaving, or more accurately, cradle-weaving. The project is a woven cradle for the Old House in Cutchogue, Long Island. I’m using white ash splints I pounded off a log some time ago. I soaked them in water for a while, then began “dressing” them. Sometimes this means scraping the splint by pulling it under a heavy slojd knife; like this:

Other times it’s peeling them apart. Score across the splint, bend the “tab” back to begin to divide it, then pull. Here’s an old, brief clip:

Once they are cleaned up, I cut them to the widths I need. Sometimes just a pair of scissors is all that’s needed. The uprights are heavier; both thicker & wider, than the weavers (horizontals). I had measured and photographed an old woven cradle at the Museum of Fine Arts in Boston, that was the basis for this one. I started in with the base woven like a large placemat. Below I’m adding in the short uprights:

Then measuring to arrive at the right size base. My uprights were a little wider than those on the old cradle, so I used slightly fewer of them, but just stopped when I hit the right dimensions.

I need lots of weavers for this project. I made a slitter for slicing the weavers. I’ve never seen one of these tools in the flesh, so I made this one up. It has a series of X-acto knife blades embedded into the end of a narrow pine offcut. Then I screwed a cap of oak to the end grain to keep the blades from slipping:

Then I pull a splint across it, slicing the ash into weavers. I’ve rarely used such a tool, I usually just use scissors. But this basket requires a lot of weavers…

 

Because I’m pretty new to using a tool like this, I don’t really quite “have the technique” yet. Here’s a short view of the action

 

It’s always cumbersome getting the big ones going. They want to flop around a lot…I keep it moist, and bend each side as I weave around it.

After a while, it begins to take shape and I can coerce each “wall” upright, then weave around & around.

It’s beginning to hold its shape on its own.

I weave with a continuous spiral around the basket; here I’m overlapping a new weaver under the end of the previous one.

Next up is figuring out how to weave the hood; I’m splicing in 9 side uprights so they’ll reach across and loop over the top. The long bits to my right form part of the hood at one end of the cradle.

I got this far & quit to take Rose to her violin lesson. Tomorrow I’ll pack these rows down tighter (after they dry overnight) then add a few more to bring the main body of the cradle to its finished height. Then tackle the hood.

Advertisements