This clean-up is harder than I thought. It takes longer, anyway. There’s a pile of baskets, the best of which are here – some finished, some nearly so. All of these were sitting up in the loft for a year-plus. But at least now they can get used.
Here’s the ones for today’s work – I have some last bits of hickory to split, shave & bend for handles & rims.
Two stools – the one on the right is brand-new, just finished last week, maybe it was the week before.
The joined stool is #3 of a pair. I made parts for three when I was making them for the Cutchogue Old House project. Then realized the order only called for two. So this stool, all turned & joinery cut, went up into the loft. I brought it down when I was prepping for my Winterthur demo last month, did some quick carvings on the rails, then pinned it. Today I plan on making the seat board, pinning that & tomorrow painting it red.
Birch bark canisters.
Ugh. I am very taken with this work, but have only spent a little time with it. Last fall Plymouth CRAFT hosted a class by Jarrod Dahl – and I learned a lot from those sessions. This one I had cut the finger joints some time ago, made a bottom, but ran out of bark so couldn’t make the bands that usually go around the upper & lower ends. I decided last week to forget them, and made a top for it, and fitted it with a basket handle. A little chip carving finished it off. 6 1/2″ diameter, 9″ high.
While moving some large books around in the house, I found a small sheet of birch bark that I had flattened & forgot about. It turned red – I don’t know if that was from the book, the paper between it & the book or what.
Some post & rung work:
The ladderback chair I started during Plymouth CRAFT’s first chair class early in May. It came home in pieces, but I figured I better build it now or just burn it. Assembled it yesterday. Slats are next. The stool parts beside it are overflow from the finished stool above. So I’ll finish both of these up, then they are slated to get rush seats instead of hickory bark.
In my cleaning, I keep running into bits of wood stored around – “Oh, that’s going to by X, Y or Z someday.” This one is mahogany – a wood I have never used. I think Bob Van Dyke gave it to me. One little piece, what could I make from one piece? One of Roy’s sliding lid boxes.
I’m not going to spoil it for those that don’t know these little puzzles. You can watch him make one here – https://www.pbs.org/video/dovetailed-grease-pot-bmswsp/
And look – one more. This carved box only needs a lid and some paint to call it done. OK, I know what I have to do now, better get away from this desk and do it.