I’ve been carving a lot of oak lately. Boxes and drawer fronts in this pile.
As I mentioned the other day, I have a box with a drawer underway; for a descendant of William Searle, one of the Ipswich joiners. These pieces get big and heavy – about 15″ tall, 26″ wide. Maybe 16″ deep.
I’ve only seen one & 1/2 period examples of this form, this one is based on the full example. The 1/2 example has lost its drawer; got cut in half at some point. Both were by the same maker(s); sometimes attributed to William Searle, sometimes to Thomas Dennis.
Lots of layout involved, and the outlines are struck with gouges and chisels, not cut with a V-tool. Centerlines, margins, arcs – all measured off with a compass. In this case, I’m trying to make a close copy, usually I make my own versions of this “strapwork” design.
But I got ahead of the story. While I had the box with drawer underway; I got an email asking if I would make a copy of the “other” one, the one that’s lost its drawer! And it had nothing to do with my having the first one on the bench. What are the odds that I’d get that note while working on a related box? I’ve got the first one to the point where all the hard parts are left – the drawer, applied moldings around the middle and base, and turned feet for underneath. Then the lid. I need to shoot some of that for the book I have underway, so rather than get involved in that right now, I got out a board to start carving the next box front.
It’s fun to see how the strapwork designs relate to each other, and how they are different. Scale is quite similar, about 5 1/2″ to 6″ high x 25″ wide.
I wrote in detail about strapwork back in 2013 – I found it by searching “strapwork” on the blog’s sidebar. https://pfollansbee.wordpress.com/2013/02/08/strapwork-carving-designs/