The bedstead’s headboard is moving along. Once I had the first free-hand panel carved, it was easy to carve the 2nd one. After marking out the margins and a vertical centerline, I used a compass to take a few markers – here noting where the S-scrolls at the bottom corner hit the vertical margins.
Then I chalked in a rough outline for that shape. This panel, like many from this grouping (and all 4 in this headboard) have a stylized urn at the bottom center of the panel. That shape I marked out with a square & awl to locate its top & bottom, and marked its width from the vertical centerline. The S-scrolls then fit between the urn and the bottom corner/margin.
My camera-boy (Daniel, 11 yrs old) came by & used the Ipad to shoot some Instragram stuff…here’s some leftovers. Carving this bottom corner S-scroll, in two snippets. (home-video caliber – no edits, shaky, etc – but worth a look.)
there are related S-scrolls across the top section of the panel. These reach from the corners to the vertical centerline. These top and bottom sections are the first things I block in with the V-tool.
then comes the stuff between. I sketch the vein in the larger leaf, it reaches from the centerline to the margin.
Then I carry on, doing first one side, then the other.
The whole thing is about filling in the spaces, and in this case, blending one shape to lay against another.
Here’s the V-tool outline almost all done.
Next I take a #5 gouge, in this case about 1″ wide or slightly less, and chop out between the V-tool lines, to begin removing the background.
Some beveling, some shaping. With a narrow #5.
People ask about the background punch. Mild steel, filed to leave these pyramidal points.
accents with a few #7 gouges.
And a narrow chisel. Bevel towards the waste when chopping like this.
Then pare down to the chopped mark.
Bevel the back, first with a hatchet.
Then 2 planes. Feather down to nothing.
Here’s the headboard thus far. There will be plain panels below this, and a carved crest rail above. And of course, two vertical posts.